Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
admin:printer_installation [2020/10/05 23:45] – [Setup] Craig Drown | admin:printer_installation [2021/03/31 14:46] – Gary Willetts | ||
---|---|---|---|
Line 1: | Line 1: | ||
{{indexmenu_n> | {{indexmenu_n> | ||
- | ====== | + | ====== |
We recommend **Zebra GK420t** label printer with a network port.\\ | We recommend **Zebra GK420t** label printer with a network port.\\ | ||
Line 27: | Line 27: | ||
==== GK420 Flash sequences ==== | ==== GK420 Flash sequences ==== | ||
- | This is a menu on the printer itself that you access by holding down the Feed button.\\ | + | This is a feature |
- | With the printer power on and top cover closed, press and hold the Feed button | + | |
- | It will flash on and off 1 time\\ | + | |
- | ...then on and off twice\\ | + | |
- | ...on and off 3 times\\ | + | |
- | ...on and off 4 times\\ | + | |
- | ...on and off 5 times\\ | + | |
- | ...on and off 6 times\\ | + | |
- | ...on and off 7 times\\ | + | |
- | You can select each of the below menu items by **releasing** the button | + | |
- | after the light starts that specific number of flashes and before the next flash sequence starts. | + | |
- | - Print a configuration status label | + | |
- | - Auto Media calibration: | + | |
- | - Serial port config: not needed | + | |
- | - Factory defaults: Sets everything back to default settings | + | |
- | - Print width adjustment (above) | + | |
- | - Print Darkness (Density) Adjustment | + | |
- | - Manual media calibration (you most likely don't need this) | + | |
==== Calibrating the printer GK420 ==== | ==== Calibrating the printer GK420 ==== |