Differences

This shows you the differences between two versions of the page.

--- admin:printer_installation [2026/02/26 23:28] – [GK420 (discontinued model)] Nick Pendergrast
+++ admin:printer_installation [2026/02/26 23:31] (current) – [Calibrate labels for ZD421] Nick Pendergrast
@@ Line 21: / Line 21: @@
 ==== Print out the configuration/IP of ZD421 ====
-To print the IP address - and other config details - hold the **FEED** & **CANCEL** buttons at the same time until they flash once
+Once you have connect your ZD421 to your network you can print the IP address - and other config details - by holding the **FEED** & **CANCEL** buttons at the same time until they flash once
 ==== Change settings of ZD421 via the http interface ====
@@ Line 42: / Line 42: @@
 ==== Calibrate labels for ZD421 ====
-To calibrate the ZD421 to recognise the label size Press and hold **PAUSE** & **CANCEL** at the same time for two seconds, then release. The printer will feed out a few labels to make measurements
+To calibrate the ZD421 to recognise the label size Press and hold **PAUSE** & **CANCEL** at the same time for two seconds, then release. The printer will feed out a few labels to take measurements.
 If the calibration does not work as desired then manual adjustment may be required
@@ Line 136: / Line 136: @@
 NOTE: **Defragmentation** is a normal operation of the GK420t printer.  The printer will defragment its memory both after a factory default and when the printer detects that a defragment is required.  When the printer is in this condition, allow it to finish defragmenting. If this warning occurs frequently then refer to the printer user guide as some label format changes could resolve this.
-==== Zebra TLP 2844 ====
+===== Zebra TLP 2844 =====
-You may have an old label printer : Zebra TLP 2844
+You may have an even old label printer : Zebra TLP 2844
 Click to download the user guide for  {{ :admin:zebra_manual-tlp_2844.pdf |Zebra TLP 2844}}