Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
| admin:printer_installation [2026/02/26 23:29] – [Zebra TLP 2844] Nick Pendergrast | admin:printer_installation [2026/02/26 23:31] (current) – [Calibrate labels for ZD421] Nick Pendergrast | ||
|---|---|---|---|
| Line 21: | Line 21: | ||
| ==== Print out the configuration/ | ==== Print out the configuration/ | ||
| - | To print the IP address - and other config details - hold the **FEED** & **CANCEL** buttons at the same time until they flash once | + | Once you have connect your ZD421 to your network you can print the IP address - and other config details - by holding |
| ==== Change settings of ZD421 via the http interface ==== | ==== Change settings of ZD421 via the http interface ==== | ||
| Line 42: | Line 42: | ||
| ==== Calibrate labels for ZD421 ==== | ==== Calibrate labels for ZD421 ==== | ||
| - | To calibrate the ZD421 to recognise the label size Press and hold **PAUSE** & **CANCEL** at the same time for two seconds, then release. The printer will feed out a few labels to make measurements | + | To calibrate the ZD421 to recognise the label size Press and hold **PAUSE** & **CANCEL** at the same time for two seconds, then release. The printer will feed out a few labels to take measurements. |
| If the calibration does not work as desired then manual adjustment may be required | If the calibration does not work as desired then manual adjustment may be required | ||